T/B and plenums with blower
#1
T/B and plenums with blower
Hi all,
I need to pick ou a T/B and plenum for my build, i will be supercharged. Do I need to go top of the line like Accufab, Dragon or can I go with BBK or Performance products. If I was N/A it would not even be a question, but the blower will be providing sooooo much air flow, I thought maybe the lower priced models would be acceptable. Any thoughts?
Thanks
I need to pick ou a T/B and plenum for my build, i will be supercharged. Do I need to go top of the line like Accufab, Dragon or can I go with BBK or Performance products. If I was N/A it would not even be a question, but the blower will be providing sooooo much air flow, I thought maybe the lower priced models would be acceptable. Any thoughts?
Thanks
#3
RE: T/B and plenums with blower
Professional Products. It flows almost the same as the accufab and its alot less expensive. JMSchip actually reccommended the PP over the accufab for my application. Go with 75mm.
#4
#8
RE: T/B and plenums with blower
Well most of the work will be done in March or April , but believe me I'll be a posting fool when I start modding I'm not sure about the swap though, it might be too much and put me past 380hp. I might keep stock heads, but use PI manifold some npi blower cams. Decisions, decisions []
ORIGINAL: lizzyfan
Keep us updated on swap and F/I
Keep us updated on swap and F/I
Thread
Thread Starter
Forum
Replies
Last Post
Dragonus18
4.6L (1996-2004 Modular) Mustang
8
09-09-2015 01:21 AM