mach 1
#1
mach 1
Hey i was looking into selling my 5.0 and getting a mach 1 i was wondering under boost if anyone new the limitations of the block/ and does the mach 1 have the same short block as the 03 cobra??
#5
RE: mach 1
ORIGINAL: Clutch_2000GT
but it is the same 4 valve motor as the cobras, just without the built botton end, so it could/should be able to handle more then the limitations of the 2 valve motor which is around 425 (safely)
but it is the same 4 valve motor as the cobras, just without the built botton end, so it could/should be able to handle more then the limitations of the 2 valve motor which is around 425 (safely)
The rods will not hold any more than a GT
#9
RE: mach 1
ORIGINAL: Clutch_2000GT
but it is the same 4 valve motor as the cobras, just without the built botton end, so it could/should be able to handle more then the limitations of the 2 valve motor which is around 425 (safely)
but it is the same 4 valve motor as the cobras, just without the built botton end, so it could/should be able to handle more then the limitations of the 2 valve motor which is around 425 (safely)
AGAIN SVT ENGINES ARE HAND BUILT AND ARE NOT COMPARABLE TO ANY OTHER ENGINE