Been busy...
#1
Been busy...
I haven't been posting much on this board recently....Mainly cause I got spanked last fall by an STI from the local area...Its a real basic bolt on STI, not much done, exhaust intake that kind of stuff. But anyways to my main point. I've been working hard on the stang since then. It got all of the following:
-Full Pi Swap
-Equal length cermic coated shorty headers
-Dyno tune
-Zex wet nitrous setup ( Just in case )
-Tubular K Member
-90/10 lakewood struts
-50/50 lakewood shocks
-UPR chromoly control arms
-Ford racing C-spec springs
-Subframe connectors
-welded axle tubes
-welded up torque boxes
-drag radials (haven't picked up yet, probably Mickey e.t.'s)
think i'll beat him? I also have 4.10, a complete exhuast/ intake setup, and short throw
[align=left] [/align]
-Full Pi Swap
-Equal length cermic coated shorty headers
-Dyno tune
-Zex wet nitrous setup ( Just in case )
-Tubular K Member
-90/10 lakewood struts
-50/50 lakewood shocks
-UPR chromoly control arms
-Ford racing C-spec springs
-Subframe connectors
-welded axle tubes
-welded up torque boxes
-drag radials (haven't picked up yet, probably Mickey e.t.'s)
think i'll beat him? I also have 4.10, a complete exhuast/ intake setup, and short throw
[align=left] [/align]
#5
RE: Been busy...
ORIGINAL: GreyStang
How badly did U get spanked the last time? Did you install ALL those mods since then or just some of them?
Is your's an auto or 5-speed?
How badly did U get spanked the last time? Did you install ALL those mods since then or just some of them?
Is your's an auto or 5-speed?
#7
RE: Been busy...
ORIGINAL: slow99GT
If you dont beat him I would sell your car LOL JK good luck man
If you dont beat him I would sell your car LOL JK good luck man
Thread
Thread Starter
Forum
Replies
Last Post