xxkazp3rxx

Actually I agree with Code... if you take 260 and subtract 15% you get 221... thats stock, so with those mods 226rwhp i would say... those mods add little to no power...

andy98gt

Full bolt ons w/ only 266??? I swear my car is making more then that. I beat stock LS1 T/A's and a custom celica w/ JDM turbocharged motor w/ 14 psi, beat that celica over and over. Maybe im just lucky or a good driver ???

djb1187

well dont quote me on this but i believe a PI swapped sn95 usually nets a higher compression ratio thus resulting in a bit more horsepower than us new edge guys have.

andy98gt

Well yeah i know that and my heads had been shaved so i bet my comp is around 11:1 So how much more HP could i possibly be getting??

mustang_pa

too much you should stop modding.

2000GT4.6

I was able to get a few LS1 cars from a dig and at least one from a roll at full boltons and full boltons + cams. Its all in the driver and if you run into the right LS1 car. Just stay away from a 6 speed/hardtop (no t tops) 3.45 rear geared ones and you will be ok

Full boltons should be around 260 to 270 WHP and 290 to 300 WTQ on an accurate dynojet. The PI swap will increase it a little but nohing spectacular.