2000dan2000

Anyone have any info on this intake. My '99 GT stock lower intake has the usual problem of cracking. Looking at something a bit stronger and, of course, always looking for a few more horses. Anyone have this, good? bad?
http://www.martelbrothers.com/catalo...g-p-17829.html

ZW99GT

They are better than plastic. And not that expensive. I have one.

02 Ninja

You won't have to worry about cracking it, but if you're not s/c you won't see a huge difference. I believe there was an article in Fast Fords a few months back that showed how it didn't produce that much on a n/a engine. If you plan on going the s/c route later on, or maybe upgrading your heads and cams then it's a good by. If not, just replace it with a PI

V1PWRED

I got one, it looks awsome under the hood. I am s/c havnet had a chance to see the gains on a dyno though

gt_stang101

I have it, looks nice, I didn't notice any changes in HP, but I'm n/a... (with plans to go KB [:-])

2000dan2000

Thanks! I am thinking of a KB down the road a bit, after a little re-working on a 120,000 mile motor so......thanks for the input guys!