pics pics pics
#1
pics pics pics
here are the pictures of my dash. i stole my gfs camera. i bought her a good *** one so they came out better than my cheepo. the light in the third pic is of my needle. i choped it in half by accedent.
#9
RE: pics pics pics
ok. it was easy i fount it on modded mustang . com a while ago.
with the blue you can use the tri-led from superlumination.com
the red i just used incondesent light bulbs. all the bulbs in the dash are size 74 (99-04) the 94-98 are 194. i dont know how many the 94-98 take but the 99-04 take 5 bulbs
as for the HVAC controls there are two bulbs size 194. they dont really show up real well.
now when i put them in they didnt show up and i was a little mad. ford and their smart brains put agreen tint on the back of the overlay.what you do is take the needles off get a puttyknife and you can tell where theyput glue onto the back of it to hold it in place andjust break it free.now once you get it off get 100 gritsand paper and you can sand the green tint off. to see where it is just hold up to a light.
to get the needles back on this is the fun part.DONOT PUSH ALL THE WAY DOWN JUST PUT NEEDLES ON HALF WAY. they just lift off. back to puttingthem on. i used a the HIDDEN DIGITAL TACHto put the tach where it goes just go on an open road and set cruise control so the rpms stay close. for the fuel go to a gas station and fill up and put the needle at full. for oil pres and volts youshold know where those go. i do bc i watch those alot to make sure nothing is going on. and for the mph i had my gf drive nextto me at 50 and i justplaced it at 50 and i was good.
any other questions just pm me.
oh the red leds dont get them they work like crap.stick to incondesent. blue you can use leds. i dont think with blue you need to take the green tint off but i would.
they look 10000000x better in person.
with the blue you can use the tri-led from superlumination.com
the red i just used incondesent light bulbs. all the bulbs in the dash are size 74 (99-04) the 94-98 are 194. i dont know how many the 94-98 take but the 99-04 take 5 bulbs
as for the HVAC controls there are two bulbs size 194. they dont really show up real well.
now when i put them in they didnt show up and i was a little mad. ford and their smart brains put agreen tint on the back of the overlay.what you do is take the needles off get a puttyknife and you can tell where theyput glue onto the back of it to hold it in place andjust break it free.now once you get it off get 100 gritsand paper and you can sand the green tint off. to see where it is just hold up to a light.
to get the needles back on this is the fun part.DONOT PUSH ALL THE WAY DOWN JUST PUT NEEDLES ON HALF WAY. they just lift off. back to puttingthem on. i used a the HIDDEN DIGITAL TACHto put the tach where it goes just go on an open road and set cruise control so the rpms stay close. for the fuel go to a gas station and fill up and put the needle at full. for oil pres and volts youshold know where those go. i do bc i watch those alot to make sure nothing is going on. and for the mph i had my gf drive nextto me at 50 and i justplaced it at 50 and i was good.
any other questions just pm me.
oh the red leds dont get them they work like crap.stick to incondesent. blue you can use leds. i dont think with blue you need to take the green tint off but i would.
they look 10000000x better in person.
Thread
Thread Starter
Forum
Replies
Last Post