yellowstang98

ok i think i am finally getting my diablo ship burnt and installed, thank GOD! the shop that i am going to is going to charge me 120 bucks to get it burnt(with lifetime free reburns/tunes) and then i think 30 bucks to install it. and then i also have a set of used march pulleys that i think i am going to pick up too, they are only like 60 bucks and then another 30 for install. shouldnt be a bad day at all. pick up 25-20 horse maybe all for under 300 bucks not bad not bad...

yellowstang98

16 memebers viewing this forum right now(12:22am) and NOT ONE COMMENT[X(]

Dan04COBRA

Good stuff, but when are you doing a PI swap.

2000GT4.6

Unless your tune is way way off for some strange reason I don't see ya picking up 25 HP.

I dont see anything in your mods that warrents a chip and burn, why are you doing it at this time?? (unless u have more done than whats in your sig). I can tell ya with a good amount of certanty you won't pick up much with just a custom tune on a all stock setup.

I do see you have 3.73s though, guessin you are getting the speedo corrected? Have em shut the trac control off while their at it.

yellowstang98

my speedo is already corrected, but im getting the chip done to advance my timing and improve my a/f ratio and im also getting the march pulleys, and i dont think that i ever said i was going to pick up 25 hp. im hoping for like 15 with chip and the pulleys, and i think thats reasonable. and PI SWAP is a little more money that i have to spend right now, i am thinking of just getting the PI intake for now b/c i dont have that type of money to do a complete swap

vshayes

well congrates. It looks like you will have a good day!.

Dan04COBRA

Heh, you definitely said it homeslice. Anyways, good luck. Time for a PI swap...

2000GT4.6

You should get some drag radials. Or maybe do an xpipe/catback. D/rs will probably be your best bang for cheap buck other than N20