Help, Can't take off stock H-pipe
#1
Help, Can't take off stock H-pipe
I was able to get the dreaded header bolts off easily, what I am having troubles with is the o2 sensors. I was able to get 1 of the rear o2 sensors off but the front ones will not budge. I am using a 20 or 22mm open ended wrench. I have sprayed the **** out of them and given it all my strength and nothing. Any recommendations/opinions are appreciated!! lets get my x-pipe on today[&:]
#3
RE: Help, Can't take off stock H-pipe
So you think I should start it up for a little bit and let it idle until it gets warm? If I throw a code doing that it will be cleared the next time I unhook the battery right?
#4
RE: Help, Can't take off stock H-pipe
yeah unhook battery and code will be cleared but it will come back unless u fix whatever the code is
and as far as running it... if u dont have a set of torches or propane torches to heat the pipe.. go for it.. just dont burn ur *** and be careful!!!!!!!!!!!!!!
and as far as running it... if u dont have a set of torches or propane torches to heat the pipe.. go for it.. just dont burn ur *** and be careful!!!!!!!!!!!!!!
#6
RE: Help, Can't take off stock H-pipe
Just unplug the wires and work on it out from under the car. If you don't havea torchalready go to Home Depot or Lowes etc etc and get yourself a Bernz-o-Matic turbo torch head and a bottle of Mapp gas. Heat all around the bung and it should come loose, done this many times, good luck.
Thread
Thread Starter
Forum
Replies
Last Post
mungodrums
S550 2015-2023 Mustang
7
09-29-2015 09:18 PM
ccdguy
5.0L (1979-1995) Mustang
1
09-19-2015 05:20 PM