speedometer sticking after gauge install
#1
speedometer sticking after gauge install
Hey guys, I am having a rather unfortunate issue after installing my white face gauges. The instructions said to avoid moving the speedometer and tach needles when installing the gauge overlay, I really did not move them much at all but for some reason the speedometer would work perfect one day and not the next. Basically I would accel and it would have to make jumps to catch up and then hang up at 50 or wherever even when I would decel.
I had them out the other day and the overlay is not making the needle hang up on it or anything, I am really kind of confused about the whole thing. It would really suck to have to buy new gauges b/c I wanted to make my gauges white[>:].
Any ideas on how to fix this?
I had them out the other day and the overlay is not making the needle hang up on it or anything, I am really kind of confused about the whole thing. It would really suck to have to buy new gauges b/c I wanted to make my gauges white[>:].
Any ideas on how to fix this?
#2
RE: speedometer sticking after gauge install
I had the same problem. The needles are too close to the guage face now and occasionally drag across it. Take a flat screw driver and gently pry the needle up about 1/8 of an inch. (pry from the middle of the needle where it attaches to the cluster)
#3
RE: speedometer sticking after gauge install
ORIGINAL: pete1665
I had the same problem. The needles are too close to the guage face now and occasionally drag across it. Take a flat screw driver and gently pry the needle up about 1/8 of an inch. (pry from the middle of the needle where it attaches to the cluster)
I had the same problem. The needles are too close to the guage face now and occasionally drag across it. Take a flat screw driver and gently pry the needle up about 1/8 of an inch. (pry from the middle of the needle where it attaches to the cluster)
Thread
Thread Starter
Forum
Replies
Last Post