Estimated numbers/times
#21
5th Gear Member
Join Date: Dec 2004
Location: In between Your Mom's Titties, skeet skeet..
Posts: 2,045
RE: Estimated numbers/times
Hey 2000GT4.6, did you have an idea of what you're putting to the ground?? I'm assuming you have a 5-spd...
Have you brought your car to the track yet?? It looks like you pretty much have all of the bolt-ons you could get, minus aluminum driveshaft, intake spacers, phenolic spacers for your headers, maybe a few other add-ons that aren't so much power adders, as they are enhancers (i.e. better radiator/thermostat, light weight things like seats, trim down on extras)..
Just wondering.. Almost sounds like you could be at high 12's w/ a good launch...
JT
95 Eagle Talon TSi AWD - 12.7 @ 103mph (R.I.P.)
00 Mustang GT - Too Slow to Race, so far....
Have you brought your car to the track yet?? It looks like you pretty much have all of the bolt-ons you could get, minus aluminum driveshaft, intake spacers, phenolic spacers for your headers, maybe a few other add-ons that aren't so much power adders, as they are enhancers (i.e. better radiator/thermostat, light weight things like seats, trim down on extras)..
Just wondering.. Almost sounds like you could be at high 12's w/ a good launch...
JT
95 Eagle Talon TSi AWD - 12.7 @ 103mph (R.I.P.)
00 Mustang GT - Too Slow to Race, so far....
#22
RE: Estimated numbers/times
O.K. guys I have a auto and with the mods listed in my sig. (except for the pullys wich are going on this fri.) on street tires I ran a 9.03 in the 1/8 mile and was spinning bad off the line and then again from 1-2 shift. I have a new set of rims/tires going on this thir. (BFG KDW's 285/40/17 rear) and am going to have the u/d pullys installed on fri. along with a dyno tune. When I get all this done I am going to the track on Fri. night to see what it will run. I will let you all know what I Dyno at and what my times are at the track. And I am not running a d/r just the BFG KDW's.
Thread
Thread Starter
Forum
Replies
Last Post