Cannot find any thread about tapping manifold
03-20-2009, 08:41 PM
#1
2nd Gear Member
Thread Starter
Join Date: Mar 2008
Location: South Carolina
Posts: 232
Cannot find any thread about tapping manifold
I have been searching through this site for an hour and cannot find an article that shows how to tap the second coolant sensor. I know how to tap it, i just need to know exactly what tap to use and were to get it. I seen somewhere that said to use a 3/8-18 but i have tried everywhere and can only find a 16 thread count.
03-21-2009, 02:29 AM
#4
2nd Gear Member
Join Date: Aug 2008
Location: Seymour Johnson AFB, NC
Posts: 445
I went to a ace hardware( dunno if they have those everywhere) and the 3/8- 18 was the most expensive one.
to tap it I used a 1/2 inch drill bit and tapped it from there aluminum is pretty easy to cut with those taps
to tap it I used a 1/2 inch drill bit and tapped it from there aluminum is pretty easy to cut with those taps
Thread
Thread Starter
Forum
Replies
Last Post
uberstang1
Classic Mustangs (Tech)
6
09-20-2015 06:42 PM
