Help me out guys =)
#1
Help me out guys =)
Whats up guys.. I just installed a pypes x-pipe and I think i may have to go back over my steps again because when I tightened everything up on of my mufflers stuck out farther than the other (pass side muffler was barley visible from the back). And also when I started the car up it sounded alittle funny and I seen smoke comming from the passenger side also......any ideas on what that could be? Not white smoke or black.....more like clean exhaust smoke but i dunno. Could it be the pypes stickers burning off could it be a bad oxygen sensor? or maybe just not lined up right with the header port?
Black 2000 Mustang GT
Automatic 60,000 on the clock
CIA K&N
Flowmaster Super 44's
Shorty Antenna
Many More Mods Soon.....
Black 2000 Mustang GT
Automatic 60,000 on the clock
CIA K&N
Flowmaster Super 44's
Shorty Antenna
Many More Mods Soon.....
#2
The smoke could of just been something getting burned off your new x pipe. I know new mufflers or any type of piping usually smells like its burning something off especially when you go through the gears at full throttle when their brand new.
Thread
Thread Starter
Forum
Replies
Last Post