1999mustang2000

i have a nitrous kit on the way and im gettin the car ready and ive already got plugs and everything now for tuning i have a diablosport hand held tuner and a steeda timing adjuster and i wanna remove the adjuster and just use the tuner for the timing and i was wondering how to i go about doin this and would i need anything else?

Stevecooper

Remove the adjuster and install the sensor back in its original location. not much to it really. Just take five seconds to look at it.

1999mustang2000

i didnt put this on but i thought in order to put one of these on you have to remove one of the pullys?

1999mustang2000

any other answers and where does the stock sensor go? anyone have any pics of the stock pulley layout

00perfredgt

You have to have the original crank pulley bolt to remove adjuster. The simplest way to solve your problem is to set the adjuster to stock timing. Loosen three allen bolts on adjuster. Turn adjuster to 10 degrees(stock setting), retighten allen bolts. Make sure you keep those tight . Good luck.

1999mustang2000

do i need the crank pulley its self or is it still there? and does anyone have the part # for the bolt

00perfredgt

Remove pulley/ damper bolt. Replace with shorter stock bolt. torque to spec.Unplug wiring harness from crank position sensor. Remove 3 AC retention bolts, and pull compressor out of the way. Support compressor so as not to damage AC lines. Remove adjuster bracket. Remove sensor from bracket. Install sensor in hole . Bolt in place. Reinstall AC bolts,wiring harness, and surpentine belt. Have fun!

1999mustang2000

forget that...stock timing it is

Stevecooper

If I remember correctly...

remove the bolt that holds the pulley in place. Remove the adjuster and reinstall the bolt (technically you should replace the bolt but most do not)

The sensor goes in the side of the timing cover, bottom left.

1999mustang2000

forget that...stock timing it is