blew ssomething going for 3rd gear in a brake stand?
#1
blew ssomething going for 3rd gear in a brake stand?
welp..i was in front of my house, had some buddies over 1999 GT was there, and i did a powerbrake in first, hit second, put it to 7k rpms and hit third, went in too easy, it hit and then just gave up...u can see all 3 gears marked on the pavement, but i coasted into the driveway, nd no broken pieces, leaking fluid, clutch cables good, driveshaft does NOT spin....i can go through everygear with no clutch and the car wont stall, did i bend the shift forks? the bone T-45 has only 6k on a rebuild...any suggestions?
#2
i did a powerbrake in first, hit second, put it to 7k rpms and hit third, went in too easy, it hit and then just gave up
i can go through everygear with no clutch and the car wont stall, did i bend the shift forks?
the bone T-45 has only 6k on a rebuild...any suggestions?
i can go through everygear with no clutch and the car wont stall, did i bend the shift forks?
the bone T-45 has only 6k on a rebuild...any suggestions?
Last edited by Tim99GT; 10-19-2009 at 02:45 PM.
#5
Well, what the hell did he think was going to happen???
The stock transmission is just that - stock. Its not built to take that kind of abuse. Yea, burnouts in 1st gear are ok, but when you start switching gears while doing the burnout your asking for trouble. And to top it all off, your spinning it to 7K rpms..... you mind as well drive down the highway doing 70ish and slam the damn thing in reverse...
#6
^hahaa ok fair enough, but 1st things first, my motto is.."its a cobra..what can't it do.." lol which is not always the case, but like i said only 6K on the rebuild, and it was rebuilt to be stronger than stock...abd i was only turning at 7k to get some spin in 3rd witht he 3:55's....so yes good point..u joint isnt too bad? i just bought 85 fox, so wasnt looking to blwo another load ont he cobra....can change the u joint myself?
#8
I would imagine so, if it's only a u-joint. You said it's going through all gears without the clutch and not stalling? And your gears aren't grinding from shifting without the clutch? Please correct me if I misread what your saying, but if this is true, I'd say you have bigger problems than just a u-joint.