PCV Catch Can and Breather Filter
#1
PCV Catch Can and Breather Filter
Does anyone have a link for a nice catch can set up for my Procharger?
Also, i'm assuming the type of filter doesn't matter that I will be putting on the driver side valve cover?
Thanks
Also, i'm assuming the type of filter doesn't matter that I will be putting on the driver side valve cover?
Thanks
#2
the best is using AN fittings on the valvecovers with -10 hose coming from each valvecover to the catch can. to keep the oil from seeping out and running down the back of the valvecovers. you can use the same AN fittings that are used for fuel tanks, but youll have to remove the valvecovers to install them. If you dont want to do that you can try just using heater hose and clamps, but it may leak. Technically you only need to vent one cover, but i like ventilation to be evenly distributed. modularmustangracing.com makes a good kit, but it only comes with enough hose and fittings to vent one cover for $130. I think a real high quality setup will cost in the $200 range for both covers
#3
#6
No problem as I have been researching these cans for quite a while. Just found another new one from Moroso on TMS and it looks to be another nice option. http://forums.themustangsource.com/s...d.php?t=478813
Thread
Thread Starter
Forum
Replies
Last Post