Almost done with the T-56 swap.
 

Hey guys, Its been a long time since i have been on here but i need some help. I have finished putting my new t-56 in my car and got the headers and everything back on. But now i have to work on my driveshaft. I know i need to get it shortened by an inch and i need a 27 spline yoke. My question is would a driveshaft shop have yokes there that i could buy (i would think so) and also if you know happen to know of a good driveshaft shop in central ga. Pictures will be up soon of the swap. Its my busy season right now and today is my only day off for the next 3 weeks so any advice you all could give me would be greatly appreciated!

Take a look at my T-56 swap thread (in sig) and may be of some help. When I did mine, I had my DS custom made to fit per specs of my swap.

Jazzer :)

Thank jazz, i actually based most of my swap off of yours. It was very helpful. Well i drove to Atlanta and got Driveline services of Atlanta to shorten my drive shaft by an inch. Dwight (the owner) was very professional and timely. I highly recommend him. Anyways, I got back to the shop and i ran into a new problem with my front u joint. I need a 1350/1330 u joint since im using a 27 spline yoke (03 cobra) and shortened GT drive shaft. a So im going to napa tomorrow and get one and it will be done! :) I'm getting so far behind at work but i don't care lol. I'm just ready to have my mustang back!