Sheet Metal Intake Flanges?
#1
Sheet Metal Intake Flanges?
Just wondering, does anyone know where i could get flanges that bolt up to PI 2v heads in order to make a custom 2v intake manifold?
i've been tinkering with the thought of a couple designs, and i had an amazing idea of getting an air-water intercooler core and putting that in the manifold itself, with the intake runners coming out of the top/side, and the thottle body down low but in the center just above to alternator, almost like a logan intake. of corse i would want to use an oval TB if i could.
this would essentially remove a boatload of intercooler piping.
sure its a crazy idea, but all good ideas are spawned from some crazy idea at some point.
i've been tinkering with the thought of a couple designs, and i had an amazing idea of getting an air-water intercooler core and putting that in the manifold itself, with the intake runners coming out of the top/side, and the thottle body down low but in the center just above to alternator, almost like a logan intake. of corse i would want to use an oval TB if i could.
this would essentially remove a boatload of intercooler piping.
sure its a crazy idea, but all good ideas are spawned from some crazy idea at some point.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
mungodrums
S550 2015-2023 Mustang
10
09-28-2015 10:54 PM
mrappe
V6 (1994-2004) Mustangs
0
09-26-2015 10:16 AM