Superchager
#2
just so you know the intake manifold to bolt it to is more expensive than the actual charger, hope you didn't buy it yet.
#3
yea, i've seen many people get screwed into thinkin they can get an M90 or M112 for 300-400$ thinkin they can just bolt it up to the intake manifold only to find out that the 2v doesnt have an acceptable platform like that for cheap.
i wonder though, if one had adapter plates, or had a set made for the intake manifold - they could just weld up their own stainless steel sheetmetal intake? i wish i could find a way to replicate the flanges for the bottom of the manifold for cheap, i'd be tempted just to try it, only problem would be the intercooler core.
edit: i have seen sheetmetal intakes for use with M112 eatons, but they were non-intercooled, and something like 1100-1300$.
i wonder though, if one had adapter plates, or had a set made for the intake manifold - they could just weld up their own stainless steel sheetmetal intake? i wish i could find a way to replicate the flanges for the bottom of the manifold for cheap, i'd be tempted just to try it, only problem would be the intercooler core.
edit: i have seen sheetmetal intakes for use with M112 eatons, but they were non-intercooled, and something like 1100-1300$.
Thread
Thread Starter
Forum
Replies
Last Post
Mark_Dubai_2005GT
GT S197 General Discussion
8
12-10-2006 10:55 PM