How can I tell if I have had engine upgrades done?
#21
All you have is a email tune, aluminum driveshaft and a catback. Neither of those mods add any significant amount of power.
And people can't be bad at driving an auto, unless his foot wasn't physically long enough to push the pedal to the floor, you'd have to be a dumba$$ to be a bad auto driver from a roll.
The heavy hitters are heads, cams, full exhaust and a dyno tune. Obviously other than a supercharger/turbo/nitrous
And people can't be bad at driving an auto, unless his foot wasn't physically long enough to push the pedal to the floor, you'd have to be a dumba$$ to be a bad auto driver from a roll.
The heavy hitters are heads, cams, full exhaust and a dyno tune. Obviously other than a supercharger/turbo/nitrous
#22
My friend (who rides a bike) was actually behind the wheel during those curves, while I was messing with the camera (new HD Drift). I'll make sure to bust his ***** for his driving.
#23
Took pics of my car this week, just to confirm some of the parts and I had a couple questions:
1) This is the connection from the mid-Pipe to the Flowmaster exhaust. Is this the stock H mid-pipe/cats? Just to confirm, I'm assuming the 2nd pic shows an alum driveshaft?
2) These look like the stock camber plates, what are the additional holes for? Did someone have aftermarket plates installed previously?
1) This is the connection from the mid-Pipe to the Flowmaster exhaust. Is this the stock H mid-pipe/cats? Just to confirm, I'm assuming the 2nd pic shows an alum driveshaft?
2) These look like the stock camber plates, what are the additional holes for? Did someone have aftermarket plates installed previously?
Last edited by Syracuse315; 10-18-2011 at 10:45 PM. Reason: Resizing Picture
#24
AL. drive shaft
stock mid pipe
stock CC plates....extra holes? I don't know. maybe previous owner installed aftermarket CC plates which required drilling extra holes.
stock mid pipe
stock CC plates....extra holes? I don't know. maybe previous owner installed aftermarket CC plates which required drilling extra holes.
Last edited by smitty2919; 10-19-2011 at 06:57 AM.
#25
Thread
Thread Starter
Forum
Replies
Last Post