65mechanic

Okay guys. I've seen this thread portrayed on several other forums (F150 Forums SHOUT OUT!) and I think the 4.6 side of this forum should have one too. I couldn't find one already started and hopefully it'll become a sticky so lets keep her going! SO, What did you do to your Mustang today?

1998Slow 'Stang

Replaced heater hoses and intake manifold gaskets on my '98. It wasn't fun at all.

Shredder505

today, I put redline hood struts on my pony

johngt10

Deleted that stupid pipe that runs from the intake elbow to your firewall just so it can add more engine noise to your cabin. I didnt have a problem with it until the baffle that sits inside the tube dissapeared. When I punch it I hear nothing but intake noise. Its louder than my damn exhaust and doesnt sound good to me at all lol. I need an aftermarket elbow that connects from the throttlebody to the cold air though. It looks a little redneckish right now. I shoved an expansion plug in the hole for now lol.

03FASTGT

Today I drove my mustang.

Franchi

Took my first shot of the two Mustangs together with my new iphone :-) And attempted to edit it somewhat....obviously still learning....

jrp1588

Clayed it yesterday for the first time ever. It pulled out a TON of stuff, especially on any horizontal surface like the roof or trunk. The rear bumper and behind the rear wheels was also a mess. After that I gave it a good wax and put on some tire dressing. It's looking the best it has since I bought it.

Now if only I could get the roof repainted and get some new headlights to replace my crappy fogged up ones.

stevednmc

Today I left mine in the garage because its snowing, I drove my beater cavalier, the best thing I ever bought for my stang.
I also sent my SCT tuner in to be unlocked. Previous owner sold his stang and didnt reset back to stock beforehand.

Sxynerd

I slid the K-member back under the car today but had to move it again once I noticed I have a leak from PS Rack lines.

Syracuse315

Put on the black billet grille (dremmeled most of the honeycomb out behind it) and painted the pony emblem.

Have the lower grille, hood grille and painting the badges before the blackout is complete.