-8 AN tubing?
Why is it that everywhere i go i cant find -8 AN tubing? i'm looking to swap to a return style setup and have everything cept the line and fittings. i was planning on running a -8 from two external walbro pumps (using Y connector) & to a FPR up front then using the old line as a return.
i suppose i could use two smaller lines and run them to the FPR? was planning on using stainless steel hard line (rubber = no go, and braided = expensive, so i'll only use it for the small flex relief areas), but if it comes down to it and i cant find stainless i'll prolly break down and go aluminum. i called all the FLAPS and they seemed like it was crazy that i wanted fuel line that big? most only had 1/4 or 3/8, and i think napa also had 5/16. Most also seemed to think that i wanted copper line? very odd. any help? |
AN sizes are based off a 16th
8/16 = 1/2" tubing, thats overkill for such a low hp setup, you'd be perfectly fine with 3/8s tubing or (6/16's) 6an lines |
low HP setup?
i'm lookin for 20lbs of boost soon. |
All times are GMT -5. The time now is 06:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands