97stanger

Yesterday I just booked my meth dyno tune which will be getting done at Dez Racing. I am about a 5 hour drive, so I'll be trailering it to him on Saturday, March 24. So next Saturday. I have an AIS trunk mount system, tri nozzle setup with a progressive controller. I am running two 4gph pre throttle body, and a single 3gph pre blower. Rodney from AIS wants me to try a 5ph, and a 7gph pre blower as well so I ordered them today. I'll be running a 50/50 mix. The car put down whats in my sig without meth at only 14 degrees of timing. Any guesses on what she'll put down after the meth tune? Keep in mind this is through an intercooled auto. I am personally shooting for 550/490, and that may not be that high but I dont want to be disappointed! I'll be sure to post up dyno sheets

wolverine8490

Let me know how this goes as I have a stage one system from AIS mounted, just waiting to hook it up...

TRUEBLUE3934

I'll be anxious to see how much you gain from this set-up.
Since you are already IC, it will be interesting to see what you can tweak out of it with some more timing.

dwtjr3

I have been waiting to see the results of this for months now! haha.

I dont think you are going to see too much of a gain from the cooling aspect of the meth since your already I/C'd, I think the boost in the octane is gonna give you good numbers. I would say with the 5gph and 7gph you should see close to 570/500. thats my guess. Good luck with your tune tho man, nice to see one of us actually is doing their winter builds on time lol

97stanger

I came across a small bump with my mondo valve crapping out, but I have new one on order and should have it all setup still for Saturday. Thanks guys, I'll be sure to post up results.

dwtjr3

Wow didnt you just install that? Is it covered under warranty? And any reason as to why it did?

Reason i ask is for future reference when i upgrade mine

97stanger

Vortech claims its a 1 in 10000 thing. I hooked it up, connected vacuum and my car was surging like crazy. Plugged vacuum line with my finger and car would run perfect. Took mondo valve back off and put a vacuum pressure gun to it, it wasnt holding any vacuum, it should open at 4-5" vacuum, it would open, but seep down and close and it wouldnt stay open. I sent it back to them and ordered a new one. Vortech is inspecting, and will reimburse me so yes its under warranty.

dwtjr3

That sucks man, good thing you figured it out before your 5 hour drive to the dyno haha. And good thing you dont have to pay for it either

97stanger

yeah man I guess if I had to have it happen I'd rather catch it now ya know. Should be getting the new one tomorrow, and hopefully it will be on the car so we can make sure all is good

sn95_331_GT_ yellow

hell yeah bro!!!! pm me!!!