Any Ideas On custom Licence plate ??
10-03-2005, 06:31 PM
#7
1st Gear Member
Thread Starter
Join Date: Aug 2005
Posts: 58
RE: Any Ideas On custom Licence plate ??
ORIGINAL: Emann0007
GMKILLA, CBRAKLR..... you better have some good mods though....
GMKILLA, CBRAKLR..... you better have some good mods though....
hmm the CBRAKLR i like, but it kinda sucks cause my friend has a cobra and i'll be putting on the Kenne Bell 2.4L blower on his next week... so ... yeah theres one cobra that will destroy me.
i have a bunch of mods but i have no idea what i should be pushing... the car will be all done as of wensday of this week. Anyone have any similar mods that can give me an idea of what to expect?
Heads...
Swirl polished Valves (manley)
Titanium retainers (crower)
Valve springs (crower)
Cams (crower) .475 exhaust , .473 intake lift
Ceramic coating of Combustion chamber on heads
Ceramic coating of Valve face.
Block/internals...
bored .030 over
11:1 Compression Forged pistons (CP)
Manley Forged Rods
Lighten balance Crankshaft
balance rotary Assembly (Rods, Pistons, Crank, Flywheel, Pressure plate)
High pressure Oil Pump (Ford Racing)
Ceramic Coating Of top of piston Heads
Suspension...
Spec Stage 2 Clutch (rated for 530 lbs of torque)
18x9 front 18x10 rear Saleen wheels (chrome ...=heavy :O( but looks nice haha) with BF goodwrich G-Force tires
Bolt Ons..
K&N cold air
Yes its still on a stock exhaust.. i ran out of money though :O( ... Still Need 4.10 gears, aluminum driveshaft, H&R lowering springs, long tube headers with x pipe, loudmouth 2 exhaust.. and definetly dyno tuning
any horsepower/torque estimations from all you gear heads?
