Caster Camber Plate Kit
#1
Caster Camber Plate Kit
I have a 2004 convertible 4.6 and purchased the EIbach Pro Kit. My mechanic suggested that I get the caster camber kit so I can get the car aligned properly. I searched and could not find the correct Eibach kit for the springs. Any help? Thanks in advance. Ed.
#2
How low are you going? Also our cars have a fair amount of camber movement with out the plates. We if you take off your top bearing plate you'll notice it is slotted but has a tab stopping it from sliding, cut the tab off and you'll have a lot more camber movement. If you want camber caster plate then pretty much any of them from 94-04 will work, they are all same. It doesn't matter what springs you have on. Also there are 3 bolt camber caster plates and 4 bolt. I'm a fan of the 4 bolt and use them in our cars because with the 4 bolt ones you have even clamping pressure on the bearing and plate and it doesn't wear out that much, but you have to drill a new hole for the fourth bolt and slot it like the other three. If you go 3 bolt camber caster plate you just need to put it in, no funny business. Just be in mind that if you get a cheap 3 bolt one that you have uneven clamping pressure and in my case it makes a ton of noise over time.
#3
#5
#8
buy the 4 bolt set, like these. much stronger
http://www.maximummotorsports.com/st...roducts_id=256
http://www.americanmuscle.com/qa1-ccplates-9404.html
I run the qa1 and they are beefy. I really like the mm ones too.
http://www.maximummotorsports.com/st...roducts_id=256
http://www.americanmuscle.com/qa1-ccplates-9404.html
I run the qa1 and they are beefy. I really like the mm ones too.
#9
The problem with the four bolt cc-plates is that they aren't a direct bolt on, but we sell those too:
http://www.uprproducts.com/mustang-c...es-4-bolt.html
http://www.uprproducts.com/mustang-c...es-4-bolt.html
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM