question ab mustang gt chassis
#2
By the time you push what's left of a 20 year old bushing out of that lca (which I assume is on a V6 car) I don't think what's left of it will be in good enough condition to make it a worthwhile venture. Not sure on fitment, chances are there are slight differences in the bushings.
If you're on a tight budget I would just go on RockAuto and look up a set of new replacement bushings (they may actually sell an entire replacement arm with bushings if I had to guess). Your local parts stores may also be able to source them, can't imagine they are terribly expensive. If you wanna replace the lca's with something better then I use and recommend Maximum Motorsports, anything they make. Not cheap though. UPR makes a decent set for less than $200 (last I checked anyway).
If you're on a tight budget I would just go on RockAuto and look up a set of new replacement bushings (they may actually sell an entire replacement arm with bushings if I had to guess). Your local parts stores may also be able to source them, can't imagine they are terribly expensive. If you wanna replace the lca's with something better then I use and recommend Maximum Motorsports, anything they make. Not cheap though. UPR makes a decent set for less than $200 (last I checked anyway).
Last edited by Z28KLR; 10-16-2018 at 12:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post