removing starter?? 97 GT
#2
RE: removing starter?? 97 GT
Its a huge pain in the ***...i just had mine out thursday when i put a new clutch in. Use swivels and position your hand in hte most awkward angle going straight up and then down haha...
I didnt even put the 3rd starter bolt back in...
I didnt even put the 3rd starter bolt back in...
#4
RE: removing starter?? 97 GT
I think I used 2; What i did was get the actual socket on the nut by itself. then just pieced suff together from there trying stuff to beable to get to where i could get a wrench on it.
#7
RE: removing starter?? 97 GT
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
#8
RE: removing starter?? 97 GT
ORIGINAL: jmmorgan82
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
I think so, I put mine back in; but just tightened it with my hand...i figure if it falls out whatever; I dont think it will hurt anything.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
logan409
4.6L (1996-2004 Modular) Mustang
10
09-26-2015 07:43 PM