Port and Polish job cost?
#11
RE: Port and Polish job cost?
just a thought, PI swap components run u at least 800+ but NPI P&P costs around 500, just a thought, but P&P to the PI heads would run you a lot of money, o well I'll might end up orderign a p&p PI kit for 1400 comes with valve stuff and whatnot
#12
RE: Port and Polish job cost?
ORIGINAL: XxphantomsnypzxX
just a thought, PI swap components run u at least 800+ but NPI P&P costs around 500, just a thought, but P&P to the PI heads would run you a lot of money, o well I'll might end up orderign a p&p PI kit for 1400 comes with valve stuff and whatnot
just a thought, PI swap components run u at least 800+ but NPI P&P costs around 500, just a thought, but P&P to the PI heads would run you a lot of money, o well I'll might end up orderign a p&p PI kit for 1400 comes with valve stuff and whatnot
ORIGINAL: JonBeast
It was SPECULATED in another thread, there is NO proof.
*PI outflow NPI
*P&P NPI outflow PI
*P&P PI outflow P&P NPI
End of story
It was SPECULATED in another thread, there is NO proof.
*PI outflow NPI
*P&P NPI outflow PI
*P&P PI outflow P&P NPI
End of story
I'll make it look easier to understand.
PI>NPI
P&P NPI>PI
P&P PI>P&P NPI
#16
RE: Port and Polish job cost?
ORIGINAL: XxphantomsnypzxX
well actually someone on this forum has a magazine from ford that actually says if u port and polish our 96-98 heads, they flow better than the 99-04 heads when they're ported and polished just something to think about, save 800 bucks
well actually someone on this forum has a magazine from ford that actually says if u port and polish our 96-98 heads, they flow better than the 99-04 heads when they're ported and polished just something to think about, save 800 bucks
naw your wrong your thinking about the ford racing D46 heads which are about 2 grand for the pair from ford. i have a set if your interested.
#19
RE: Port and Polish job cost?
ORIGINAL: XxphantomsnypzxX
lol wow u have everything, how much are you asking for them
lol wow u have everything, how much are you asking for them
im sorry i meant if your interested in specs. i had them flow benched. here are the numbers
they topped out at 212cfm at like .600 lift
my PI heads before sean hyland got ahold of them flow benched at 155cfm at .600 lift
my PI heads after sean hyland ported them flow 229cfm at .600
so you can imagine how well these heads would flow ported.
if you search ebay for a long time you can pick these up i got mine for $600
Thread
Thread Starter
Forum
Replies
Last Post