Parts for sale soon
#1
Parts for sale soon
Save your pennys, I should have a few parts for sale soon to make room for the vortech.
C&L 80 MM MAF (for stock injectors)
C&L inlet (if the vortech kit comes with one, not sure if it does)
Diablosport 3 position switch. This is the version shops can program locally, not the mail order chip. Has a tune for my car as it is setup.
Anybody interested?? I figure I would probably sell em for 1/2 what they cost new?? All are in super good condition.
C&L 80 MM MAF (for stock injectors)
C&L inlet (if the vortech kit comes with one, not sure if it does)
Diablosport 3 position switch. This is the version shops can program locally, not the mail order chip. Has a tune for my car as it is setup.
Anybody interested?? I figure I would probably sell em for 1/2 what they cost new?? All are in super good condition.
#3
RE: Parts for sale soon
Tim at modular power house says it will be no problem at all, so long as you don't try to make 550+ RWHP. It is acutally supposed to make quite a bit more than a stock cammed car. Tim is promising between 400 and 420 RWHP on a safe tune. Said he has a stage 2 car setup basically like mine making 440 RWHP on pump gas !
#4
RE: Parts for sale soon
nice! i hope to see some numbers some time soon!.... I think it was you, but i'm still pi55ed i missed out on those free steeda pulleys...[:@]. Let us know if there is anything else your interested in getting rid of.
#6
RE: Parts for sale soon
ORIGINAL: David_K
your putting a blower on a N/A cammed car
your putting a blower on a N/A cammed car
the VT/comp lines of street cam shelf grinds work very well with blowers. a MM&FF tested 4.6 2V making 655 hp lost 105 hp when comp 270's were replaced with stock pi cams.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM
UPRSharad
Vendor For Sale / Group Buy Classifieds
0
09-08-2015 03:46 PM
tj@steeda
Steeda Autosports
0
09-02-2015 08:40 PM