jvog

1450 shipped with pump and pan

10inch Terror

Up to '98

10inch Terror

I assume the Manley forged I-beam Sportsmans? What dish size?

teej281

do you have pictures and specs for this shortblock???

jvog

Not sure...he told me that he thinks with my 2v heads ill have 10.5:1 compression which I have been told is too high for my blower and pump gas. I am going to get the actual piston cc from him tomorrow..

livefast1

i heard the probe pistons weren't that great for over 5 or 600 horsepower because they have really shallow skirts, once again just word of mouth.

jvog

what do you guys think about 2003 cobra forged mahle pistons with very low miles in great condition with a brand new set of file fit plasma moly rings and Manley forged h beam rods with arp 2000 bolts with very low miles. He wants 740 shipped. I would need to find a block and possibly a crank. My stock crank is good to at least 600 rwhp isnt it?

Sxynerd

I'm a tard!

jvog

At least you admit it...I was like ummm ok and ignored your post lol

jvog

so...I can get an 03 cobra longblock oil pan to heads for 1800 shipped. I really wasnt planning on a 4v swap but hmmm. Would all my accessories bolt up with a 4v? (i dont see why not). I would bracket for my vortech right...How much power can stock cobras bottom ends hold...I know its a good bit just curious