Almost done with another build
03-28-2009, 11:40 PM
4th Gear Member
Join Date: Jul 2004
Location:
Posts: 1,860
Quote:
Originally Posted by
1999mustang2000
sweet build....are you from ky? jus wonderin since JayC asked if you was goin to speedys
I'm in southern Indiana and Ox is from Clarksville Tn.
03-29-2009, 01:31 AM
Banned
Thread Starter
Join Date: Sep 2008
Location: tn
Posts: 0
Quote:
Originally Posted by
JayC
I'll roll in around 4:30 to see if you're still there.
I wont be there, I have to work.
03-29-2009, 01:32 AM
Banned
Thread Starter
Join Date: Sep 2008
Location: tn
Posts: 0
Quote:
Originally Posted by
mustangman03
what did you do to the bottom end if you dont mind me asking
.020 over forged pistons, Manley H beam rods, cobra crank.
03-29-2009, 11:18 AM
4th Gear Member
Join Date: Aug 2007
Location: Florida
Posts: 1,721
Looks slow.....jk, jk! haha!
03-29-2009, 05:20 PM
5th Gear Member
Join Date: Jan 2005
Location:
Posts: 2,616
looks pretty good. Def. post some after pics and full car pics.
03-29-2009, 05:20 PM
3rd Gear Member
Join Date: Feb 2008
Location: SC
Posts: 621
How much will the cobra crank hold and where did you get it from b/c ford wants $1500 for it did how much did the machineing cost
03-31-2009, 01:43 PM
Banned
Thread Starter
Join Date: Sep 2008
Location: tn
Posts: 0
Ok ready to go to the dyno tomorrow. Just got to go pick up the new hood and front bumper.
03-31-2009, 02:28 PM
2nd Gear Member
Join Date: Dec 2007
Posts: 402
Lets hear the bitch running!
03-31-2009, 02:45 PM
5th Gear Member
Join Date: Nov 2005
Location: MN
Posts: 4,412
Did you use a slot style MAF sensor? Otherwise were did you put it?
03-31-2009, 02:47 PM
2nd Gear Member
Join Date: Dec 2007
Posts: 402
Quote:
Originally Posted by
mustangman03
How much will the cobra crank hold and where did you get it from b/c ford wants $1500 for it did how much did the machineing cost
I have them for less than half that $$$$.