i'm gonna put turbos on my 5.4 4 valve....but
#11
Id go with "h" beam connecting rods. and forged pistons(better with heat and stronger) try and get your top compression ring set a little farther down to reduce micro wielding. get some nice plasma-moly rings. you could prob get thinner bearing, for more performance(nascar status lol) but if you want your motor to last for more then 500miles get decent sized bearing.
#13
thank you with all the help everyone, i'm thinking I beams only because i want something that will last, i wont be raping the hell out of the car either, i take care of my stuff, though there will be fun had with it. as far as hp goes, anything over 850 will be fine, i'd like a 1K horse car, but it wont kill me not to have it. there is a guy who threw a video on youtube of his 5.4 4 valve with twin turbos running 1200 hp. its a 93 i think and he drives it on the street......it runs like 7's. i want a 7 second street car....especially with only the 1.5 inch cowl.
Thread
Thread Starter
Forum
Replies
Last Post