4.6 general chat
#7162
paid a grand for the car with a bad motor, swapped in a junkyard crown vic motor, threw a 70mm on3 kit in with all the supporting fuel/suspension mods, currently hovering around 10psi.(got bored and turned the boost controller up lol) made 410/480 on 8psi. Theres about 6k total in the entire car. I went over just about everything from the trans forward and replaced it. Still need to work on the interior a bit and rear suspension.
#7164
i imagine it would fit with the stock bumper, this car came with the termi bumper. Put a 03 vic motor in it, so its identical to the mustang other than the covers and intake. i was pleased with the power it made... its literally all stock car minus the turbo and supporting mods. plan on getting a shortblock/turbo cams together next year and shooting for 600 on pump.
#7165
so is it possible to have all four O2 sensors and be the PCM. I have taken it to several mechanic shops and all they come up with is the PCM. My next step is to go to the dealer and program the new PCM i purchased since i get the theft engine code and car will not start with the new PCM.
#7168
hello everyone,
My 04 mustang 4.6 has been running sluggish and hesitation when i start in 1st gear an while driving. i have the check engine with code P2197 oxygen sensor bank 2 sensor 1. i have replace the O2 an still issue. can crossed O2 wires cause this hesitation an sometimes pop noise from my exhaust or is it a fuel issue?
Please help i taken to several shops but no one can tell me what the issue is.
My 04 mustang 4.6 has been running sluggish and hesitation when i start in 1st gear an while driving. i have the check engine with code P2197 oxygen sensor bank 2 sensor 1. i have replace the O2 an still issue. can crossed O2 wires cause this hesitation an sometimes pop noise from my exhaust or is it a fuel issue?
Please help i taken to several shops but no one can tell me what the issue is.