Edelbrock Ultra Low Profile Intake Elbow??
#11
Yea, shoulda thought about how much everything else to support the manifold was gonna cost. lol looking at what you've been going through makes me want a TFS manifold instead of this one. Plus Nick says its a better manifold above 7500rpm or under boost so I'm gonna try it out with a monoblade accufab.
#12
Yea i mean i just needed an intake at the time. And this one was the cheapest i foud that would also help me out down the road. I mean its not really THAT expensive for the 6061...just making sure you have everything before you put it on...thats all.
#13
Well for me, i dont even have a tb/plenum yet...all stock. So if i'm gonna upgrade it, the eddie costs like how much, then the 6061 plenum, 75mm tb, fuel rails. I can just buy a trickflow manifold, find someone with a stock cobra throttle body and buy it cheap and have about as much into it as you do with what some argue is a better manifold. I havent researched it yet really but nick seems to like the TFS for high rpm so that should also mean it works well for boost too. Eddie is a good manifold but i havent seen a comparison of the two to show which would be better under boost yet.
Last edited by teej281; 11-18-2010 at 05:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-17-2015 07:57 PM
Daddys Girls GTs
5.0L (1979-1995) Mustang
3
09-14-2015 08:46 PM
dalefrancis88
5.0L General Discussion
2
09-11-2015 07:15 AM