started the hp292 install!
04-19-2012, 08:40 PM
#1
started the hp292 install!
Well I finally got my hands on a set of hp s292's, got them for a real good price. I got them in the mail today so i started the tear down tonight. got the valve covers off and everything except for the balancer and front cover. I friggin forgot my balancer puller at work -.- but I should be able to get it all apart and back together tomorrow, so stay tuned for an idle vid! 
04-19-2012, 09:03 PM
#3
^ stock springs. they're saposed to work fine with these cams. I have a set of comp hi loads on my longblock that's sitting on the stand, so it'll have upgraded springs once i put the new setup in.
04-19-2012, 09:08 PM
#4
5th Gear Member
Join Date: Feb 2010
Location: PA
Posts: 2,758
They can use stock springs? I should try and find a set to throw in my car then cuz im running stock springs, but i am running CMS stage one NA cams. I need blower cams now.
But i dont want to spend the money right now, or get a retune haha.
Post a video when you can
But i dont want to spend the money right now, or get a retune haha.
Post a video when you can
04-19-2012, 09:32 PM
#6
5th Gear Member
Join Date: Feb 2010
Location: PA
Posts: 2,758
Yeah man I would love to buy some blower cams, my car is currently tore apart and am spending a lot of $ on my blower right now so new cams are out of the question right now. I need to stop spending so much money on my car Haha.
04-19-2012, 09:57 PM
#9
Actually no, the entire drivers side took 5-10 minutes. The bolts were all simple to get to with a long extension swivel socket and air ratchet. And it came out like butter. The passenger side was the bitch. The Trans dipstick I had to bend, ac lines were a pain, and I forgot to bring my fuel disconnect tools so had to squeeze it out under the line. That side took about 20 minutes. I was only in the garage for an hour and got that far.
