T-3650 question
#1
T-3650 question
hey, i just pulled out my engine and transmission from my 2004 mustang gt. its has a t-3650 transmission and i am trying to separate the transmission from the engine. everywhere i read it says it should just pull apart and i have been trying and i can not separate them. is there a trick to separating the the engine from transmission? theres about an 1/2 gap between the engine and transmission and i can spin the transmission but can't completely separate them. thanks for the help
#2
hey, i just pulled out my engine and transmission from my 2004 mustang gt. its has a t-3650 transmission and i am trying to separate the transmission from the engine. everywhere i read it says it should just pull apart and i have been trying and i can not separate them. is there a trick to separating the the engine from transmission? theres about an 1/2 gap between the engine and transmission and i can spin the transmission but can't completely separate them. thanks for the help
They should just pull right apart. With a 1/2 inch gap, I doubt it's a bolt holding it. Is the shifter handle hitting up top?
#4
user error...if all 13mm bellhousing bolts are out, and the 2 13mm bottom plate bolts are out, it should slide off....try wiggling with 2 pry bars on either side of the "1/2inch gap"
if you fail to do this, you are a complete zilch...
if you fail to do this, you are a complete zilch...
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
3
10-02-2015 08:06 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM
treesloth
New Member Area
4
09-28-2015 07:03 AM