MustangForums.com

MustangForums.com (https://mustangforums.com/forum/index.php)
-   4.6L General Discussion (https://mustangforums.com/forum/4-6l-general-discussion-88/)
-   -   2002 Mustang GT Won't Crank Please help, I'm going CRAZY (https://mustangforums.com/forum/4-6l-general-discussion/734087-2002-mustang-gt-wont-crank-please-help-im-going-crazy.html)

urdj07 04-19-2018 10:58 PM

2002 Mustang GT Won't Crank Please help, I'm going CRAZY
 
Hello everyone, and thanks in advance for any help. i recently purchased a 2002 Mustang GT with manual transmission, from an auto auction, the car was in really bad conditions and not drivable, after putting some work and money into it, it is getting a better shape, but now it won't crank at all, I verified the following:

-Starter, selenoid, ground and 12v, all good.
-Negative and Positive battery post, cables, etc, all good.
-Fuse Rellay, all good.
-Ignition Switch, replaced just in case but same thing.
-tested the battery and recharge it, same thing.
-Internal fuses, all good.

I don't know what else to check, when I thought the car was almost finished, now i giving me this problem and is driving me crazy.

I will really appreciate any comments and help.
Thanks.

WhiteFoxGT 04-20-2018 08:55 AM

so what happens when you turn the key? does the starter engage but not turn the motor... you sure the motor isnt locked up?

urdj07 04-20-2018 09:38 AM


Originally Posted by WhiteFoxGT (Post 8621052)
so what happens when you turn the key? does the starter engage but not turn the motor... you sure the motor isnt locked up?

​​​​​​
when I turn the key, all accessories works, but won't crank, the motor does run only If I bypass the starter directly connecting the selenoid and 12v cable, or if I push the car and release the clutch. My guess is maybe the clutch starter safety switch is broken or disconnected.

fastbackford351 04-20-2018 02:24 PM

Sounds like a good place to start looking.

Derf00 04-20-2018 11:59 PM

Check the alarm module in the car. If that's interrupting the circuit it would run how you describe. You may need to replace or completely remove the module. Dealers usually installed it under the drivers side dash.

WhiteFoxGT 04-21-2018 07:32 AM

happy hunting


https://cimg5.ibsrv.net/gimg/mustang...9fe8b7434b.png

https://cimg6.ibsrv.net/gimg/mustang...62b43f47d4.png

urdj07 04-21-2018 11:07 AM

Finally I've found the problem, a wire connector was unplugged next to the Hood release latch cable (pull handle) I was trying to find volt continuity from the ignition switch to the Rellay and boooom, found that sucker unplugged, plugged it back in and BIMGO. the car starts normally. 😂😂🤣🤣 Cannot be more happier. Thabks for all the suggestions guys. I do really appreciate it.https://cimg7.ibsrv.net/gimg/mustang...661a0ecefc.jpgThe one on the far right was unplugged.

fastbackford351 04-21-2018 12:57 PM

and BIMGO was his nameo


All times are GMT -5. The time now is 01:13 AM.


© 2024 MH Sub I, LLC dba Internet Brands