nhvickery

anyone have any advise on the best way to install l/t header....should i drop the engine? or is it even worth doing myself?

WHITE99GT

No need to drop engine. Does help to jack engine up and remove motor mounts for easier access but no need to drop engine. I used the dynatech supermaxx system with catted x-pipe. Perfect fit. Did use a lift and had a buddy but only took around 4 hours to install

Twister086

i usedmy lift at work and i didnt even take out the motor mounts. the only things i removed from my car was the steering shaft and my drviers side engine torque limiter. not a hard job at all... with a lift.

nhvickery

all i have right now r ramps to drive my car up on.....i have a friend with a lift but his truck is on it right now...should wait for him to get done so i could us it....not sure how long its goin to be

scramblr

I don't think you're going to have enough room with just the ramps. I did my Kooks in the garage on jack stands and put the car up as high as I was comfortable with and it' still a tight fit under there. Had enough room to work, but with only the ramps it would have been a biotch...