4.10, CAI, XCT, Dyno Tune (little gain)
#1
4.10, CAI, XCT, Dyno Tune (little gain)
Guys,
Just installed 4.10 gears, SCT 2, Steeda CAI, and dyno tune and only have 281 HP and 297 TQ. Baseline was 267 HP, 285 TQ. Any thoughts from folks that have similar mods on an 06 and been to the dyno? SAE smoothing is 0, Dyno was Dynojet. By the way with K&N Drop in, and SCT gain was only 3hp and 3 tq!
Thanks.
Just installed 4.10 gears, SCT 2, Steeda CAI, and dyno tune and only have 281 HP and 297 TQ. Baseline was 267 HP, 285 TQ. Any thoughts from folks that have similar mods on an 06 and been to the dyno? SAE smoothing is 0, Dyno was Dynojet. By the way with K&N Drop in, and SCT gain was only 3hp and 3 tq!
Thanks.
#7
RE: 4.10, CAI, XCT, Dyno Tune (little gain)
Yea, you need to investigate into that one and ask your tuner what the hell went wrong...
I got a canned tune for my engine...got pullies, delete plates, intake and a tune from Steeda....
although i havent dyno'd yet, the tuner said that I should be over 300 NO PROBLEM...and by the way its driving, i'd say hes prolly right...
a dyno tune only pulls about 2-4 more HP than a good canned tune from a reputable tuner (steeda, brenspeed, etc).
Start over and go back over that tune, theres your problem!
I got a canned tune for my engine...got pullies, delete plates, intake and a tune from Steeda....
although i havent dyno'd yet, the tuner said that I should be over 300 NO PROBLEM...and by the way its driving, i'd say hes prolly right...
a dyno tune only pulls about 2-4 more HP than a good canned tune from a reputable tuner (steeda, brenspeed, etc).
Start over and go back over that tune, theres your problem!
Thread
Thread Starter
Forum
Replies
Last Post