Mushroomed a flywheel dowel pin
#1
Mushroomed a flywheel dowel pin
I am installing a new exedy flywheel and clutch. I hammered in the first couple dowel pin into the flywheel and somehow ended up mushrooming the third one. I then noticed that one of the other pins had been slightly mushroomed as well. I used a dremel to grind down the two dowels enough so that they fit in the pressure plate.
Will this cause any issues?
If so, should I be looking to install new dowels or just remove them and install the flywheel with no dowel?
Will this cause any issues?
If so, should I be looking to install new dowels or just remove them and install the flywheel with no dowel?
Thread
Thread Starter
Forum
Replies
Last Post
Clean 14
General Tech
5
02-22-2016 04:23 PM
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
2
02-16-2016 06:54 AM