Delete plates on an NA motor?
#21
Brenspeed still has 7 of the economy $150 plates left if you talk to Chandler. I just ordered some for mine since I didn't want to get stuck paying $300 for the billet ones if I had waited.. Since I'm probably going to get a centri eventually these make a lot of sense to me even if the gains are minimal.
#24
Thanks for all the replies guys. I bought the economy ones, and just got my updated tune from BAMA. Now I just need to figure out exactly how to get the tunes from my computer to my Xcal.
Can't wait to put these on. I'm doing a lot of work to the car at the same time. UDP, Front sway bar, springs, shocks, camber plates, LCA relocation brackets and sequential tails lights. I'll probably have the car off the road for a good month or two before all is done.
Can't wait to put these on. I'm doing a lot of work to the car at the same time. UDP, Front sway bar, springs, shocks, camber plates, LCA relocation brackets and sequential tails lights. I'll probably have the car off the road for a good month or two before all is done.
#27
All this talk about losing low-end torque, and yet Steeda claims the exact opposite on their site:
* Up to 10 horsepower increase with better low end torque
(http://www.steeda.com/products/steed...ion_plates.php)
That's some marketing...
People who use their cars for....driving around? Not everyone's trips are 1/4 mile long at full throttle.
* Up to 10 horsepower increase with better low end torque
(http://www.steeda.com/products/steed...ion_plates.php)
That's some marketing...
who care about lost low end torque?
Thread
Thread Starter
Forum
Replies
Last Post
maestro1024
Classic Mustangs (Tech)
6
09-21-2015 02:40 PM
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM