2nd gear grinding?
about 6 months ago i replaced my clutch and flywheel. I have the triax shifter, and just the past couple days going from 1st to 2nd it grinds alittle bit while shifting. But if i go from third down to second or start off in 2nd there are NO issues at all. Any ideas what could be causing this? Something not aligned right or became loose?
|
Is it hard to get into 1st or reverse from a stop?
|
actually awhile back reverse was hard to get in there so i tightened the shifter bolts. This second gear this is a new issue.
|
Originally Posted by sweetlou69
(Post 7137519)
actually awhile back reverse was hard to get in there so i tightened the shifter bolts. This second gear this is a new issue.
|
spec stage 2/ aluminum fly wheel
|
Originally Posted by sweetlou69
(Post 7138147)
spec stage 2/ aluminum fly wheel
|
ah ****ty really? it was fine for the first few months, its just of late. its a pain tho
|
Im not exactly sure but I dont think the new stangs have an alluminum flywheel. If they dont I would not change it.. ill have to check...
|
All times are GMT -5. The time now is 07:19 AM. |
© 2024 MH Sub I, LLC dba Internet Brands