Analog 1 Working on SCT/SF# but not working in LiveLink?
#1
Analog 1 Working on SCT/SF# but not working in LiveLink?
Hi All,
Wasting alot of time on this. I have my wideband reading and datalogging on my SF3 handheld on Analog 1 working fine.
When I add Analog 1 and set the equation in LiveLink, it doesn't register at all.
My thought process here is that if the Analog 1 is working correctly on the handheld, shouldn't it work in LiveLink?
I am hoping there is a trick to make this work...
Thanks
Wasting alot of time on this. I have my wideband reading and datalogging on my SF3 handheld on Analog 1 working fine.
When I add Analog 1 and set the equation in LiveLink, it doesn't register at all.
My thought process here is that if the Analog 1 is working correctly on the handheld, shouldn't it work in LiveLink?
I am hoping there is a trick to make this work...
Thanks
#3
When is the last time you updated the firmware? Check www.sctflash.com tech page, that might be it. Easy way to check perhaps...
#4
When is the last time you updated the firmware? Check www.sctflash.com tech page, that might be it. Easy way to check perhaps...
Last edited by hollywub; 10-12-2011 at 09:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post