Porting stock heads?
#2
#3
RE: Porting stock heads?
I'll let you know when I get my car back together.
I took a decent amount out of the intake side and smoothed the curves a little, and then took out a pretty good amount on the exhaust side, including the thermactor bumps. I also did this on heads that were dipped, magnafluxed and had a 3-angle valve job done on them.
BTW, I did it all w/ my Dremel and some of the grinding bits.
I took a decent amount out of the intake side and smoothed the curves a little, and then took out a pretty good amount on the exhaust side, including the thermactor bumps. I also did this on heads that were dipped, magnafluxed and had a 3-angle valve job done on them.
BTW, I did it all w/ my Dremel and some of the grinding bits.
Thread
Thread Starter
Forum
Replies
Last Post
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM
kawiguy827
5.0L GT S550 Tech
0
09-01-2015 07:09 PM