building 308, need answers
#1
building 308, need answers
Hi fellas, im getting things togather to build a 308 for my mustang, and have a couple questions. I plan on installing a B303 cam with edelbrock rpm intake and heads 2.02/1.60 valves and 1.7 roller rockers. Can anyone tell me what kind of lift im going to get from this setup? I plan on using KB Silvolite fly cut pistons in this engine and wonder if i'll have any clearance problems. Also can anyone estimate what kind of torque/HP im going to get from this setup? Thanx, and any suggestions are appriciated.
BTW, this isnt a race car, but a weekend driver that needs some rumble.
BTW, this isnt a race car, but a weekend driver that needs some rumble.
#2
RE: building 308, need answers
Your lift is .510 w/ the 1.7's. You should have enough clearance. I would double check the specs on those valve springs just to make sure they are good to that lift. I'm sure they are, but better safe than sorry.
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM