1989 GT to LX
#41
RE: 1989 GT to LX
ORIGINAL: 91stang
there will be holes in the side
ORIGINAL: 89GTRed
does anyone have any idea if you can take those ugly *** side mouldings of the gt w/out having holes or something else ugy under there? Mine are kinda coming off and i was wondeing if i could just use a heat gun and pull em off... any ideas?
does anyone have any idea if you can take those ugly *** side mouldings of the gt w/out having holes or something else ugy under there? Mine are kinda coming off and i was wondeing if i could just use a heat gun and pull em off... any ideas?
there will be holes in the side
#42
RE: 1989 GT to LX
I know on my 89 Gt i removed the side moldings and it was only held on my sticky foam and no holes the only holes were when i took off the rear one by the bumper there are 3 holes left over that you need to full.
#43
RE: 1989 GT to LX
ORIGINAL: Oshawa 5.0
I know on my 89 Gt i removed the side moldings and it was only held on my sticky foam and no holes the only holes were when i took off the rear one by the bumper there are 3 holes left over that you need to full.
I know on my 89 Gt i removed the side moldings and it was only held on my sticky foam and no holes the only holes were when i took off the rear one by the bumper there are 3 holes left over that you need to full.
#46
RE: 1989 GT to LX
well, i just took a look at my cars mouldig which i never really looked at too close till now. I thought you coud just take the mouldings off all th ay around but its like part of the rear gt body kit fender and the front and rear bumbers...
guess i wont be taking them off after all..[:@]
guess i wont be taking them off after all..[:@]
#48
RE: 1989 GT to LX
ORIGINAL: Valcore
I say, "let lx's be lx's and GT's be GT's" I don't like to mix and match [:'(]
I say, "let lx's be lx's and GT's be GT's" I don't like to mix and match [:'(]
Thread
Thread Starter
Forum
Replies
Last Post
Cannibal_carnies
Motor Swap Section
3
03-02-2023 06:17 PM