5.0 differences
05-07-2006, 08:22 PM
#1
Thread Starter
Join Date: May 2006
Posts: 2
5.0 differences
I am new to the forum, I have a 1987 GT with no motor or trans. I have bought a 5.0 and a tremec out of a 1995 GT, does anyone know what problems I will run into putting that motor in the car? If anyone can help me it would be great!
05-07-2006, 09:22 PM
#2
6th Gear Member
Join Date: Feb 2006
Location:
Posts: 5,263
RE: 5.0 differences
same engine, funny dog leg intake on the intake manifold
only difference in 94-95 5.0's.
Just use a computer and wire harness from 94-95 stang too.
87's were set-up for speed density computers, 89 and new are mass air.
make sure you use new motor AND trans mounts.
i think 87 only had 7.5" axle too. ( could be wrong )
only difference in 94-95 5.0's.
Just use a computer and wire harness from 94-95 stang too.
87's were set-up for speed density computers, 89 and new are mass air.
make sure you use new motor AND trans mounts.
i think 87 only had 7.5" axle too. ( could be wrong )
05-07-2006, 09:33 PM
#4
4th Gear Member
Join Date: Feb 2004
Location: Lansdale, Pa
Posts: 1,192
RE: 5.0 differences
ORIGINAL: r.barn
same engine, funny dog leg intake on the intake manifold
only difference in 94-95 5.0's.
Just use a computer and wire harness from 94-95 stang too.
87's were set-up for speed density computers, 89 and new are mass air.
make sure you use new motor AND trans mounts.
i think 87 only had 7.5" axle too. ( could be wrong )
same engine, funny dog leg intake on the intake manifold
only difference in 94-95 5.0's.
Just use a computer and wire harness from 94-95 stang too.
87's were set-up for speed density computers, 89 and new are mass air.
make sure you use new motor AND trans mounts.
i think 87 only had 7.5" axle too. ( could be wrong )
Thread
Thread Starter
Forum
Replies
Last Post