Would this work?
#1
Would this work?
I am just tossen some idea's around and was wondering if this is a good setup. http://cgi.ebay.com/ebaymotors/FORD-...21458048QQrdZ1 Also could I bolt stock 5.0 engine parts right up to it? And would tuning need to be done? Would this be good start to build around 450hp, I would first put stock 5.0 parts on then a few more months down the road put a good H/C/I setup on it.
#2
RE: Would this work?
Yea it could be OK but I dont think those are forged pistons.... if your going to replace the motor atleast get forged internals. A forged crank and stuff is not necessary but definetly get forged pistons if your going to replace it.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-01-2015 08:16 PM