95GrandTouring5.0

I ordered a bbk cai for my 95 gt mustang. I finally got it and never got around to trying to install it until tonight. I did not even take the ****ing air box off before I had a problem that I can't do nothing about atm. Well there is a electronic sensor plugged or should i say screwed into the stock rubber hose. Now the bkk has a hole for this sensor, however the sensor does not fit in this thing tightly, it sits there lose and if i hit a bump in the road with it, it would fall out. So pissed off i put the car back together and threw the bbk **** back into the box. The installation directions were off of summit and didn't help worth 2 ****s. So here is a picture of what I am talking about and someone who installed this kit on their car please fill me in. ( Sorry for the language not in a good mood)

http://img63.imageshack.us/img63/1430/bbkha1.jpg

ACE

umm go to a local parts store and ask for a rubber grommet to put the sensor in the intake?

black89gt

^ +1

jthorn9

There should be a rubber gasket in the kit that goes into the hole, the IAT sensor then screws into the hole by means of the gasket. Look at my pic.

[IMG]local://upfiles/22329/952060AD56534F15B80056B367E3E209.jpg[/IMG]

92hatchLX

Stick it in it's poopar!

Archion

Yep, Need a grommet

Stevens91gt

..disgusting haha

95GrandTouring5.0

Can you give me a close up picture of that part, I can not see it well from that picture and i see no rubber gromet that came with the kit.

Asylum839

did you check everywhere in the box it came in, its pretty small so it can get lodged just about anywhere?

XPBaller

QFT!