HCI install...few tech q's
#1
HCI install...few tech q's
Just planning ahead (gotta wait till winter to do the install[:@]), so...
-How should I break in the cam? Same as gears/new engines, just be nice and don't take it too high in the rpm's for ___ miles? (how many?)
-How do I degree the camshaft? Any other cam install tips would be good, this will be my 1st cam install
-How do I set valve lash?
-How should I break in the cam? Same as gears/new engines, just be nice and don't take it too high in the rpm's for ___ miles? (how many?)
-How do I degree the camshaft? Any other cam install tips would be good, this will be my 1st cam install
-How do I set valve lash?
#4
RE: HCI install...few tech q's
If the car in question is the one in your sig, no break-in period is necessary. As rmodel65 said, a roller cam is different from a flat tappet cam and you won't have to worry about it.
Thread
Thread Starter
Forum
Replies
Last Post
HRnB
GT350 S550 Tech
10
12-18-2015 09:35 AM
YoungStangsMan
5.0L (1979-1995) Mustang
15
09-05-2015 07:01 PM