Cobra Intake manifolds
#11
RE: Cobra Intake manifolds
I just installed one in my H/C/I project. It runs like a raped ape with no loss of bottom end at all. Quite the opposite in fact. One major problem however: The Cobra manifolds currently being sold new are made in China at the same factory that the Perfomance Products ones are. After the install, my car started consuming oil at a quart every 100 miles. The FRPP tech line said it was a known issue and supplied me with a new baffle to install, along with a new gasket set at no charge. I just had the baffle installed on the lower today. I'll report back with results.
#12
RE: Cobra Intake manifolds
i'm runnin a cobra intake..(with some porting done to it...shhhhh)... and its been oh so good to me.. however, i do plan on bumpin up to a trickflow pretty soon... but they are great and support some good horsepower..(more if you do some work to them)
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
3
11-10-2015 11:39 AM
JDWalton
4.6L V8 Technical Discussions
8
09-24-2015 08:47 PM